Coming from a world of Ender 3 machines, I’m use to using wheel locks, ABL and mesh leveling where once I dial it in, I don’t touch it again until something goes wrong. With the ECC I thought the same would apply but the few prints I did where I didn’t do the auto level first, the nozzle was too close and scrapped along the bed. Wondering if people have had a similar experience? I was only using the textured side of the bed and didn’t make any changes in the slicer. Side not, if you want to use the other side (B-smooth) you have to change the elegoo slicer setting to bed type, cool smooth plate. Took me way to long to figure that out.
0
0 comments
log in to comment.