preview
Does anyone run multiple needles at the same time when cross stitching?
My last project was mostly just a 3 stitch outline of a logo so there were large empty spaces in the middle. I started at the top then worked down the left hand side until I reached a good end point, then I went back to the top and worked down the right hand side… only realizing that I’d screwed up somewhere when it came to connect the two parts together at the bottom and they didn’t line up. Luckily, it was a small design so I only wasted an hour or three but it also wasn’t really fixable without a lot of time figuring out where I went wrong and pulling out most (if not all) of an entire side.
I decided to give it another go last night and thought it might make sense to start at the top, then do one needle+thread simultaneously on the right and the left sides. That way, I can do the row on the left side with one needle, switch over and do the right side of the same row with the other needle. With this approach, I’m always working the same row top to bottom which should prevent me from skipping/adding a row and unbalancing the sides… or at least notice it really quickly.
If you’ve done it - any tips, tricks, or warnings you’d like to send my way?
Thanks all : )
Does anyone run multiple needles at the same time when cross stitching?
My last project was mostly just a 3 stitch outline of a logo so there were large empty spaces in the middle. I started at the top then worked down the left hand side until I reached a good end point, then I went back to the top and worked down the right hand side… only realizing that I’d screwed up somewhere when it came to connect the two parts together at the bottom and they didn’t line up. Luckily, it was a small design so I only wasted an hour or three but it also wasn’t really fixable without a lot of time figuring out where I went wrong and pulling out most (if not all) of an entire side.
I decided to give it another go last night and thought it might make sense to start at the top, then do one needle+thread simultaneously on the right and the left sides. That way, I can do the row on the left side with one needle, switch over and do the right side of the same row with the other needle. With this approach, I’m always working the same row top to bottom which should prevent me from skipping/adding a row and unbalancing the sides… or at least notice it really quickly.
If you’ve done it - any tips, tricks, or warnings you’d like to send my way?
Thanks all : )


















